Current report for Bacteriostatic Water

Bacteriostatic Water lab report #86200

Bacteriostatic Water was measured by Janoshik Analytical (Prague, Czech Republic): Benzyl Alcohol 8.72 mg/ml; report #86200 is verifiable at verify.janoshik.com.

Results reported by Janoshik Analytical

Bacteriostatic Water results on report #86200
TestResultStatus
Benzyl Alcohol
  • 8.72 mg/ml
Measured
Report ID
#86200
Laboratory
Janoshik Analytical, Prague, Czech Republic
Vials tested
1
Identity test
Not reported on this certificate
Mass spectrometry
Not reported on this certificate
Lab report
Open on verify.janoshik.com (opens in new tab)

Figures copied exactly from Janoshik Analytical's own report. Open it to check every line.

How to verify report #86200

  1. Open the report from the "Full report" link. It opens on verify.janoshik.com, Janoshik Analytical's own site, not a file hosted by us.
  2. Check that the lab's page shows report #86200.
  3. The lab's report prints no lot for this sample, so none is shown here either.
  4. Compare the figures with this certificate: Benzyl Alcohol 8.72 mg/ml.

Open the report at Janoshik Analytical (opens in new tab)How to verify a Janoshik Analytical reportLook up another lot or report ID

About this page

Every lab report Peptide Hackers publishes keeps this address permanently, including after a newer lot replaces it, so a citation of report #86200 always resolves to the same figures. The Bacteriostatic Water certificate shows the current report and every earlier one; Bacteriostatic Water is supplied for laboratory research use only — not for human or veterinary use.