| Test | Result | Status |
|---|---|---|
| Purity (HPLC) |
| Measured |
| Quantity |
| Measured |
Figures copied exactly from Janoshik Analytical's own report. Open it to check every line.
HPLC purity was measured separately on each vial: vial 1 99.777%, vial 2 99.835%, vial 3 99.798%. Across the 3 vials the results range from 99.777% to 99.835%, a spread of 0.058 percentage points.
Janoshik Analytical printed no purity specification or pass/fail verdict on this report; the figure is a measurement only.
Measured content of GHK-Cu: the amount Janoshik Analytical quantified in the 3 vials it received (56.09 mg, 57.17 mg, 56.31 mg). It is a measurement of this sample, not a label figure.
This report carries no identity result: Janoshik Analytical reports measured content and purity only.
Mass spectrometry is not reported on this certificate.
High-Performance Liquid Chromatography (HPLC) is the standard analytical technique used to verify peptide purity. Peptide labs typically run reverse-phase HPLC with UV detection. The chromatogram displays retention time on the x-axis and UV absorbance on the y-axis. The area under each peak corresponds to compound quantity. Purity is calculated as the target peak area divided by total peak area, expressed as a percentage. A purity of 98% or above is the usual research-grade threshold.
Research peptides should be stored lyophilized (freeze-dried) at -20°C or below until ready for use. Avoid repeated freeze-thaw cycles. Upon reconstitution, store at 4°C and use within 30 days. Keep away from direct light and moisture. All handling should be performed under sterile research conditions by qualified personnel following applicable laboratory safety protocols.
BPC-157 + TB-500 is supplied for laboratory research purposes only. Not intended for human or veterinary use, diagnostic procedures, or clinical applications.
