Superseded — a newer Selank report replaced this one

Selank lab report #78800

Selank was tested at 99.885% HPLC purity by Janoshik Analytical (Prague, Czech Republic); report #78800 is verifiable at verify.janoshik.com.

See the current report or the Selank certificate.

Results reported by Janoshik Analytical

Selank results on report #78800
TestResultStatus
Purity (HPLC)
  • 99.885%
Measured
Quantity
  • 11.36 mg
Measured
Report ID
#78800
Laboratory
Janoshik Analytical, Prague, Czech Republic
Vials tested
1
Identity test
Not reported on this certificate
Mass spectrometry
Not reported on this certificate
Lab report
Open on verify.janoshik.com (opens in new tab)

Figures copied exactly from Janoshik Analytical's own report. Open it to check every line.

How to verify report #78800

  1. Open the report from the "Full report" link. It opens on verify.janoshik.com, Janoshik Analytical's own site, not a file hosted by us.
  2. Check that the lab's page shows report #78800.
  3. The lab's report prints no lot for this sample, so none is shown here either.
  4. Compare the figures with this certificate: HPLC purity 99.885%; Selank 11.36 mg.

Open the report at Janoshik Analytical (opens in new tab)How to verify a Janoshik Analytical reportLook up another lot or report ID

About this page

Every lab report Peptide Hackers publishes keeps this address permanently, including after a newer lot replaces it, so a citation of report #78800 always resolves to the same figures. The Selank certificate shows the current report and every earlier one; Selank is supplied for laboratory research use only — not for human or veterinary use.